STRIP-LOK™ Sheet Metal Joiner
A strip tear on a coil processing line doesn’t just cost the company time and money. It’s a major headache
for the production crew whose job it is to repair the damage.
The STRIP-LOK™ Sheet Metal Joiner is a portable strip-joining machine driven by compressed air. The main use for STRIP-LOK™ joiners is repairing strip tear off situations on modern steel strip processing lines such as continuous galvanizing and paint coil coating lines. Two models are available to suit most production facilities. This is the best advance in economical efficient and effective strip joining equipment in over three decades. Already used by major around the globe, the STRIP-LOK™ Sheet Metal Joiner is highly appreciated and valued. Repeatable, strong connections can be achieved with a total sheet thickness up to 1.8mm (0.07”).
Operation is very clean and quiet as the STRIP LOK™ Joiner does not require any consumables other than the two pieces of strip to be joined and no blank is produced.
Long-Reach Heavy Gauge
STRIP-LOK™ Joiner
Principles of Operation
The joint is achieved by mechanically punching a square hole through the sheets to be joined and folding the flared strip back onto itself. Apart from requiring an external compressed air source the STRIP-LOK™ Joiner is fully self contained. The STRIPLOK™Joiner is activated as soon as the trigger is pressed and an automatic cycle of punching and flattening the two layers of metal strip will then commence. The joining cycle will immediately stop as soon as the trigger is released.
Joint Strength
The strength of each join depends upon the gauge and properties of the metal being connected. As a general rule, 20 punches on each side of .4mm soft iron sheets provide a tensile force of approximately 25kN (5620 lbf).
Warranty Information
STRIP-LOKTM Sheet Metal Joiners are manufactured using only the highest quality materials and workmanship. The light weight housing is manufactured using a high strength grade aluminum alloy and the punch and die are manufactured usinghigh strength tool steel which is hardened and heat treated prior to assembly. The joiners are fully bench tested in the factory prior to shipping. A six months warranty from the date of purchase to the original owner is provided covering workmanship and materials of construction. The warranty does not cover miss-use. The supplier or manufacturer may decide at their discretion to repair or replace faulty equipment. A charge will be applied covering repairs to equipment damaged through miss-use, including damage resulting from the use of contaminated compressed air.
Long-Reach Heavy Gauge STRIP-LOK™ Joiner
Designed for wide strip, the LRHG Model has a reach of 300mm from the strip edge. It is not necessary to have individual joins across the entire width of the strip. Considerable stability is created in a joint of two overlapping sheets via a reasonable overlap region in the order of 700mm or more. This unit can be used to join strip widths up to 1500mm.
Long-Reach Heavy Gauge Low Pressure STRIP-LOK™ Joiner (LP)
The LP designation signifies that this model is designed for use in plants where achieving higher line air pressure is a problem. The LP model offers the same performance as the standard unit. However, only requires 450 kPa of air pressure to achieve the same capacity for joining the thicker/harder materials for which the standard unit would require up to 760 kPa to achieve.
